The Dynatex DXL Injector introduces KerfAid Lubricant into the cutting water stream during a wafer saw dicing or other processing operation that uses a continuous water supply.
The DXL Injector provides a regulated stream of a pre-mixed KerfAid to DI water ratio into the saw’s water feed. Dilution factors are adjustable, up to 100:1. The DXL Injector easily retrofits to any dicing saw and requires minimal installation or operation effort, with the ability to run multiple saws depending on saw type/model and blend ratios.
The DXL easily retrofits to any dicing saw.
Dilution factors are adjustable.
Flow meter monitors lubricant delivery to system and gives warning of empty reservoir.
Lubricant is pumped directly from 1 or 5 gallon KerfAid container.
Internal components are stainless steel, polypropylene, or Teflon™.
Automatic switch-off when saw is idle.
220/240 VAC 3.1 amp, 50/60Hz or
100/120 VAC 6.3 amp, 50/60Hz
Max Inlet Pressure - 150 psi
Nominal Operating Pressure - 65 psi
Max Outlet Pressure - 80 psi
Output Flow Rate - 37 Liters/min (@80:1 ratio of Water:KerfAid)
Inlet and Outlet Connections - ľ" NPT female
60-80 °F; 0-95% Humidity (non-condensing)
15" W, 15" D, 32.5" H
For multiple saw machine use, please inquire of the DXL Injector II.